1
Culver General Discussion / Re: Cadet STF Plans Availability?
« on: August 06, 2016, 07:08:40 PM »
Unfortunately, I have not heard back from any of the email/calls sent on the Culver STF contacts listed on Aircraft Spruce.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Culver General Discussion / Cadet STF Plans Availability?
« on: January 04, 2016, 02:35:28 PM »
Gentlemen,
Does anyone know if the plans are still available for the Cadet STF? I have sent emails and tried calling the number listed under the plans page at Aircraft Spruce. All I get is a recorded message that the number is disconnected.
What a loss to the experimental community if the plans are no longer available.
Does anyone know if the plans are still available for the Cadet STF? I have sent emails and tried calling the number listed under the plans page at Aircraft Spruce. All I get is a recorded message that the number is disconnected.
What a loss to the experimental community if the plans are no longer available.
3
Culver General Discussion / Re: Cockpit Width
« on: December 28, 2015, 01:53:09 PM »
Thank you. I just measured the rear seat on our experimental J5 at 35" and our other side by side seat experimental at 42".
I appreciate the help.
I appreciate the help.
4
Culver General Discussion / Cockpit Width
« on: December 24, 2015, 02:03:30 PM »
Simple question: what's the interior cockpit width on a Cadet?
5
Parts Wanted / Plans
« on: December 24, 2015, 02:01:11 PM »
I'm looking for a set of Cadet/Dart plans for a homebuilt project I have in mind. I have tried to contact Aero Systems, put have not heard back from them.
Thank you,
J Meyer
Thank you,
J Meyer
Pages: [1]